|
|
//功能：00～99的簡易秒表設計，兩個靜態數碼管，定時器采用 <查詢方式>
#include "reg51.h"
void delay1s() //函數功能：在T1工作方式1下的1s延時函數，采用查詢方式實現
{
unsigned char i;
for(i=0;i<20;i++) //設置20次循環次數
{
TH1=(65536-50000)/256; //重新設置T1計數初值高8位，定時時間50ms
TL1=(65536-50000)%256;
//重新設置T1計數初值低8位
TR1=1; //啟動T1
while(!TF1); //查詢計數是否溢出，即定時50ms時間到，TF1=1
TF1=0; //50ms定時時間到，將T1溢出標志位TF1清零
}
}
//函數名：disp(unsigned char i)
//函數功能：將i的值顯示在兩個靜態連接的數碼管上
//形式參數：i，取值范圍0～99
void disp(unsigned char i)
{
unsigned char led[]=
{0xc0,0xf9,0xa4,0xb0,0x99,0x92,0x82,0xf8,0x80,0x90} ;
//定義0～9顯示碼，共陽極數碼管
P1=led[i/10]; //顯示i高位
P2=led[i%10]; //顯示i低位
}
void main()
{
unsigned char miao=0; //秒計數器定義
TMOD=0x10; //設置T1為工作方式1
TH1=(65536-50000)/256; //設置T1計數初值高8位，定時時間50ms
TL1=(65536-50000)%256; //設置T1計數初值低8位
TR1=1; //啟動定時器開始計數
while(1)
{
disp(miao); //顯示秒計數器值
delay1s(); //調用1s函數
miao++; //秒計數器加1
if(miao==100)miao=0; //秒計數計滿，則從0開始計數
}
}
|
|
